Maximum Criterion Manuel d'utilisateur télécharger pdf

INSTALLATION

PROPER INSTALLATION IS IMPORTANT. IF YOU NEED ASSISTANCE, CONSULT A CONTRACTOR, ELECTRICIAN

OR TELEVISION ANTENNA INSTALLER (CHECK WITH YOUR LOCAL BUILDING SUPPLY, OR HARDWARE STORE

FOR REFERRALS). TO PROMOTE CONFIDENCE, PERFORM A TRIAL WIRING BEFORE INSTALLATION.

Form a drip loop with the wire at least eight inches

below the exit from the sensor and at least eight inches

below the point of entry into the building. Anchor any

exposed wire with insulated cable clips. Run the wire

through the building to the location where the indicator

will be located. Caulk any holes when done.

Feed the AC adaptor's cord and the sensor wire to the indicator.

Connect the the two wires of the AC adaptor cord to the back of the

indicator with the supplied brass nuts. The polarity does not matter.

Connect the two wires from the temperature sensor to #1 and #2

screw terminals (reading #1 through #5, left to rignt). The polarity

does not matter. Do not plug the AC adapter in until all of the

connections have been made and checked.

Mount the temperature sensor assembly with the two

large wood screws. Select a location that is protected

from direct sunlight and sheltered. (A north exposure, six

feet above the ground will give the best results.)

DRIP

LOOP

WOOD

SCREWS

CAULK

CABLE

CLIP

MIN

TEMPERATURE

SENSOR

ADAPTOR

Mount the brass read-out directly over the cable

feed-thru-hole to avoid crimping the wire under the lip.

We recommend mounting the read-out on one of our

pre-drilled and centered panels. Plug the power supply

into a 110 VAC power outlet.

CABLE-HOLE

WAL

SCREW

PANEL

Page 1

30 Barnet Boulevard

New Bedford, MA 02745

(508) 995-2200

CRITERION

1 2 3 4

Résumé du contenu

Page 1 - CRITERION

INSTALLATIONPROPER INSTALLATION IS IMPORTANT. IF YOU NEED ASSISTANCE, CONSULT A CONTRACTOR, ELECTRICIAN OR TELEVISION ANTENNA INSTALLER (CHECK WITH

Page 2

OPERATIONTROUBLE SHOOTING The trend register needle can be set by turning the center knob on the indicator dial. Unplug the AC adaptor and remove th

Page 3

2 OR 3 SENSOR OPTIONSCRITERIONAs a factory installed option, the Criterion has the ability to be built as a two sensor instrumentor three sensor instr

Page 4 - Recommended Prevention:

30 SAMUEL BARNET BOULEVARD NEW BEDFORD, MASSACHUSETTS 02745 U.S.A.TEL. 508.995.2200 WWW.MAXIMUM-INC.COM FAX 800.989.2580Page 4RW E A T H E R

Commentaires sur ces manuels

Pas de commentaire

Maximum Criterion Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Instruments de mesure Maximum Criterion. Maximum Criterion User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Instruments de mesure Maximum Criterion