Maximum Stratus Manuel d'utilisateur télécharger pdf

STRATUS

INSTALLATION

30 Barnet Boulevard

New Bedford, MA 02745

(508) 995-2200

PROPER INSTALLATION IS IMPORTANT. IF YOU NEED ASSISTANCE, CONSULT A CONTRACTOR, ELECTRICIAN

OR TELEVISION ANTENNA INSTALLER (CHECK WITH YOUR LOCAL BUILDING SUPPLY, OR HARDWARE STORE

FOR REFERRALS). TO PROMOTE CONFIDENCE, PERFORM A TRIAL WIRING BEFORE INST TION.ALLA

Remove the cover of the Humidity sensor to gain

access to the holes on the upper left and lower

right side of the sensor. Mount the sensor to the

wall with two wood screws. The sintered bronze

sensor house should face toward the ground.

Select a location that is protected from direct

sunlight. (A northern exposure about six feet

off the ground with good air flow will give the

best results.)

CAULK

MIN

COVER

WOOD SCREWS

Form a drip loop with the wire that

is at least eight inches below the

exit point of entry. Anchor any

exposed wire with insulated cable

clips. Run the wire through the

building to the location where the

indicator will be located. Caulk any

holes when done

DRIP

LOOP

SENSOR

BRONZE

SENSOR

HOUSE

CABLE

CLIP

Feed the AC adaptor’s cord to the rear of the indicator.

Connect the two wires of the AC adapter cord to the

indicator using the brass nuts supplied in the hardware

pack. The polarity does not matter.

TEST POINT 1

Test

Point:

INDICATOR

ADAPTER

NUTS

BRASS

1 2 3 4 5 6 7 8

Résumé du contenu

Page 1 - INSTALLATION

STRATUSINSTALLATION30 Barnet BoulevardNew Bedford, MA 02745(508) 995-2200PROPER INSTALLATION IS IMPORTANT. IF YOU NEED ASSISTANCE, CONSULT A CONTRACTO

Page 2 - INSTALLATION (CONT.)

STRATUSINSTALLATION (CONT.)5FEED-THRU-HOLECABLE-HOLECABLESSCREWWOODPANELWALLSCREWMount the brass instrument directly over the cable holeused to route

Page 3 - OPERATION

OPERATIONIt can take 12-24 hours for the humidity sensor toacclimate to its surroundings and reflect accuratereadings. Before reading your Hygrometer,

Page 4 - HEAT INDEX

STRATUSINFORMATION ON HUMIDITYDew point is the temperature at which a parcel of air reaches its saturation point and can no longerhold water in the va

Page 5 - TROUBLESHOOTING

STRATUSTROUBLESHOOTINGUnplug theAC Adapter.Remove theinstrument fromthe wall.Disconnect the AC adapter from the indicator and connect itto an AC voltm

Page 6 - TROUBLESHOOTING (CONT.)

STRATUSTROUBLESHOOTING (CONT.)To test the sensor connect a DC voltmeter to terminals#2 and #3. Terminal #2 is the ground terminal and #3the positive o

Page 7

IMPORTANT ADDITIONAL INFORMATION Components: Along with the indicator, the following components are included with this instrument:

Page 8 - Common Causes:

30 SAMUEL BARNET BOULEVARD  NEW BEDFORD, MASSACHUSETTS 02745 U.S.A. TEL. 508.995.2200  WWW.MAXIMUM-INC.COM  FAX 800.989.2580 Electrical Damage

Commentaires sur ces manuels

Pas de commentaire

Maximum Stratus Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Instruments de mesure Maximum Stratus. Maximum Stratus User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Instruments de mesure Maximum Stratus