Maximum Wireless Rainwatch Manuel d'utilisateur télécharger pdf (Page 2)

Remove the cap from the cylindrical

housing and slip the transmitter board

out of the rain collector base. Change

the jumper position from NORMAL to

TEST.

BATTERY

COMPARTMENT

TEST

POSITION

Insert two AA Alkaline batteries into the covered

battery compartment. A RED LED should blink

once as the batteries are installed. This indicates

the batteries have been installed correctly.

TIPPING

BUCKET

RECEIVER

Once the batteries are properly installed, the LED on the

Receiver should blink ORANGE every four seconds. Refer

to the troubleshooting section at the back of these instructions

if the LED does not blink ORANGE every four seconds.

ORANGE

red

led

RED

Page 2

30 Barnet Boulevard

New Bedford, MA 02745

(508) 995-2200

RECEIVER

Move the active RAINWATCH transmitter as close as possible

to your preferred final mounting location. Also move the

RAINWATCH indicator and receiver combination as close as

possible to their final mounting location. Select a location for

the transmitter that is out in the open, away from obstructions

(such as walls or trees) that would shelter the collector from

the rain in various wind directions. Be sure that the LED on the

receiver is flashing ORANGE every four seconds. If the signal

has been lost, move the transmitter to an alternate mounting

location and re-check for proper communication.

ORANGE

RAINWATCH

INSTALLATION

WIRELESS

Y1Y1

Z1Z1

R3R3

D1D1

OAP

C7C7

JUMPER

NORMAL

POSITION

JUMPER

Z1Z1

R3R3

R1R1

OAP

C7C7

ORANGE

JUMPER

NORMAL

POSITION

TEST

POSITION

JUMPER

INF

RA AL

E T

FALL

S O IUN

T F

1 2 3 4 5 6 7 ... 10 11

Commentaires sur ces manuels

Pas de commentaire

Maximum Wireless Rainwatch Manuel d'utilisateur Page 2

Commentaires sur ces manuels

Produits connexes et manuels pour Instruments de mesure Maximum Wireless Rainwatch